BHHPM - FLAW-FINDER AG-1-VS PENETRANT

Product Identification

Product ID:FLAW-FINDER AG-1-VS PENETRANT
MSDS Date:06/05/1987
FSC:6850
NIIN:00-826-0981
Kit Part:Y
MSDS Number: BHHPM

Responsible Party
AMERICAN GAS AND CHEMICAL COMPANY.,LTD.
220 PEGASUS AVENUE
NORTHVALE, NJ 07647-1904
US

Emergency Phone: 201-767-7300

Info Phone: 201-767-7300

Preparer: GEORGE KOSEL,CHIEF CHEM

Cage: 03530

Contractor
AMERICAN GAS AND CHEMICAL COMPANY,LTD
N0RTHVALE, NJ 07647-1904 US

Telephone: 201-767-7300

Cage: 03530

Ingredients

TRIPHENYL PHOSPHATE

CAS: 115-86-6

RTECS: TC8400000

Fraction By Weight: 1.0%

OSHA PEL 3 MG/M3

ACGIH TLV: 3 MG/M3; 9192


DICHLORODIFLUOROMETHANE (SARA III)

CAS: 75-71-8

RTECS: PA8200000

OSHA PEL 1000 PPM

ACGIH TLV: 1000 PPM; 9192

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

Hazards

Routes of Entry: Inhalation:NO Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:CAUSES IRRITATION OF
EYES,SKIN,RESPIRATORY TRACT;INGESTION MAY CAUSE
NAUSEA,VOMITING,ETC...INGESTION OF SMALL QUANTITIES IS USUALLY
NON-FATAL UNLESS ASPIRATION OCCURS.ASPIRATION MAY LEAD TO CHEM ICAL
PNEUMONITIS.
Effects of Overexposure:INHALATION:DUE TO ITS LOW VOLATILITY,EXPOSURE
TO THIS MATERIAL UNDER AMBIENT CONDITIONS IS NOT EXPECTED TO
PRODUCE ADVERSE HEALTH EFFECTS FOLLOWING NORMAL WORKPLACE
EXPOSURE;SKIN:CAN CAUSE SLIGHT IRRI TATION;EYES:MAY CAUSE
IRRITATION;INGESTION:CAN CAUSE GASTROINTESTINAL
IRRITATION,NAUSEA,VOMITING AND DIARRHEA.
Medical Cond Aggravated by Exposure:NONE CURRENTLY KNOWN.

First Aid

First Aid:INHALATION:REMOVE TO FRESH AIR:SEEK MEDICAL HELP.IF NOT
BREATHING,GIVE ARTIFICIAL RESPIRATION,PREFERABLY MOUTH TO
MOUTH.GIVE OXYGEN IF AVAILABLE; SKIN AND EYES:FLUSH WITH PLENTY OF
WATER FOR ABOUT 15 MINUTES.SEEK MEDICAL HELP IF IRRITATIONPERSIST;
INGESTION:DO NOT INDUCE VOMITING.IMMEDIATELY CALL A PHYSICIAN.

Fire Fighting

Flash Point:NONE
Extinguishing Media:REGULAR FOAM,WATER FOG,CARBON DIOXIDE,DRY CHEMICAL.
Fire Fighting Procedures:WEAR FULL PROTECTIVE CLOTHING AND
SELF-CONTAINED BREATHING APPARATUS.COOL EXPOSED CONTAINERS WITH
WATER SPRAY.AVOID BREATHING VAPOR OR FUMES.
Unusual Fire/Explosion Hazard:CONTAINERS MAY BURST/EXPLODE IN HEAT OF
FIRE.

Accidental Release

Spill Release Procedures:USE PROPER PERSONAL PROTECTION:REMOVE IGNITION
SOURCES:RECOVER FREE LIQUID;USE SUITABLE INERT ABSORBENT SUCH AS
SAND,CLAY,ETC.TO ABSORB LIQUID.KEEP MATERIAL OUT OF SEWERS/WATER
WAYS.LG SPILLS MAY BE P ICKED UP BY VACUUM PUMPS,SHOVELS & PLACEIN
DRUMS.

Handling

Handling and Storage Precautions:STORE IN A COOL DRY PLACE BELOW
120F.DO NOT PUNCTURE OR INCINERATE AEROSOL CANS.DO NOT STORE OR
HANDLE NEAR HEAT,SPARKS OR OXIDANTS.KEEP PLAINLY LABLD
Other Precautions:DO NOT
PRESSURIZE,CUT,WELD,BRAZE,SOLDER,DRILL,GRIND,OR EXPOSE SUCH
CONTAINERS TO HEAT, FLAME,SPARKS OR OTHER SOURCES OF IGNITION:THEY
MAY EXPLODE AND CAUSE INJURY OR DEATH.DO NOT ATTEMT TO CLEAN SINCE
RESIDUE IS DIFFICULT TO REMOVE.

Exposure Controls

Respiratory Protection:USE NIOSH APPROVED SELF-CONTAINED BREATHING
APPARATUS IF NEEDED.
Ventilation:GENRAL VENTILATION IS SUFFICIENT.
Protective Gloves:NON ABSORBENT GLOVES
Eye Protection:SAFETY GLASSES
Other Protective Equipment:USE CHEMICAL RESISTANT APRON OR OTHER
IMPERVIOUS CLOTHING,IF NEEDED,TO AVOID CONTAMINATING REGULAR
CLOTHING.EYE-WASH FAC
Supplemental Safety and Health
NSN MANAGED BY GSA IS A 3 PART KIT OF TYPE II,METHOD C;PER GSA ID,KIT
CONSISTS OF 9-7 OZ AEROSOL CANS (3 CANS EACH OF
PENETRANT,DEVELOPER,AND CLEANER);PER MIL-I-25135,REV E AND
QPL-25135-14/15,THIS PE NETRANT,AG-1-VS,IS QUALIFIED WITH D-4
DEVELOPER & CLASS(1) REMOVER;SEE PNI-B & C FOR DEVELOPER & REMOVER
DATA;KEY1:J7

Chemical Properties

HCC:V2
Vapor Pres:<.1MMHG@20
Vapor Density:>1.0(AIR=1
Spec Gravity:0.98 (BULK)
Evaporation Rate & Reference:0.1 (N BUAC=1) (BULK)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:DARK RED LIQUID;MILD ODOR
Percent Volatiles by Volume:>95%

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENT.
Stability Condition to Avoid:EXTREME HEAT
Hazardous Decomposition Products:BURNING CAN PRODUCE CARBON DIOXIDE
AND/OR CARBON MONOXIDE.

Disposal

Waste Disposal Methods:WASTE PRODUCT SHOULD BE INCINERATED OR DISPOSED
OF IN AN APPROVED DISPOSAL SITE OR FACILITY.CAN BE RECLAIMED AND
RECYCLED.ASSURE CONFORMITY WITH ALL APPLICABLE LOCAL,STATE AND
FEDERAL DISPOSAL REGULAT IONS.DO NOT INCINERATE AEROSOL CANS EMPTY
OR FILLD

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.